Toll-Free
(800) 423-4478 • Toll-Free Fax Orders (866) P-U-N-C-H-E-S
Standard
Tube Punches
Standard Tube Punches
- Outside Bevel, Center Bevel, Inside Bevel. Click
on photo for sizes chart.
Standard
Tube Punch available with rubber ejection insert. Contact us for available sizes.
Standard
Tube Punch with Spring Ejector.
Special
1/8 " Base Punches with a 7/64" or 3/32" cutting edge. Made from
high carbon steel and precision ground.
Standard
Tube Oval Punches
Standard Tube Ovals also
know as Squeezed Ovals or Oblong Tube punches. Click
on photo for sizes chart.
Tube
Style Square Punches
Sharp
corners, can be ordered with or without springs. Available in 1/8" to 1/2"
size range. Click on photo
for sizes chart.
007
Straight Cut Punches
Made
from high carbon steel with a minimum support bevel of .0075. Reduces cutting
pressure, available in 1/8" to 1/2" size range. Click
on photo for sizes chart.
Outside/Inside
Diameter Relieved Punches
Also known as serrated
punches or saw tooth punches, these punches feature a scalloped-designed bevel
that allows for less cutting pressure and added blanket life. Wagner rotary
tube punches are manufactured to exact tolerances, this translates into superior
cutting and improved stripping characteristics.
Click
on photo for sizes chart.
Notched
Tube
Notched
punches are designed to hold the slug in the die cut board for stripping later.
Available with one, two, three or more notches as required.
Straight
Outside Diameter
Available
in 1/64" increments from 3/32" to 1/2". Larger Standard sizes
are as follows: 9/16", 5/8", 11/16", 3/4" and 7/8".
Ground close tolerances are designed for applications where a standard punch
will not work. Click on photo
for sizes chart.
Rotary
Tube Serrated
O.D.
Relieved Punches are used primarily where minimum board crush is desired. Inside
relieved punches (inset photo) are used as trimming dies, as in molded parts
that protrude.
Cup
Punches
This
style punch cuts and forces the material into the "cup". The resulting
compression ejects the slug. Made from solid rod. Available sizes from, 1/16"
to 31/64". Click on photo
for sizes chart.
Pin
Points
Used
as locators, pin points are made with a sharp as standard, or can be ordered
with a blunt tip. Available in 1/8" and 3/16" base.
Washer
Sets
Designed
to be concentric, the outside and inside punch can be furnished as standard
tube or feed-thru or special or custom punch. Washer sets are all custom-made
to order.
Available in 1" high
in a variety of sizes these punches feature a 10-tooth design that produces
a clean cut with less pressure.
Click
on photo for sizes chart.
Inside-Inside
Bevel Serrated
